proTAC 5311

proTAC 5311

£1.00 Ex VAT

£1.20 Inc. VAT

High performance GSM/4G/WLAN antenna specifically for 4G/LTE routers.

  • Maximizes the 4G/LTE networks range and performance.
  • Frequency range (typical): 800 MHz – 2.6 GHz
  • Frequency range (extended): 600 MHz – 6 GHz
  • Power handling: 250 W
  • Antenna gain: Up to 5 dBi
  • Return Loss: Less than 10 dB
Availability: Available on back-order SKU: proTAC-5311

Covers all 2G, 3G and 4G frequencies worldwide, including WLAN frequencies.

Traditional cellular antennas have a very narrow bandwidth and only cover either up-link or down-link frequencies of the operators network. This causes a non-symmetrical link and a reduction in data throughput (Mbps).

Promarines innovative design makes it possible to extend the antennas bandwidth to cover both up-link and down-link frequencies at the same time and in all communication bands. This improves the radiation performance to over 90% compared to a traditional antennas best case of 60 – 80% efficiency.

Specification

  • Frequency range (typical): 800 MHz – 2.6 GHz
  • Frequency range (extended): 600 MHz – 6 GHz
  • Antenna gain: Up to 5 dBi
  • Return Loss: Less than 10 dB
  • Power handling: 250 W
  • Connectors: N-type Female
  • Antenna type: Vertical monopole
  • Grounding: DC-Grounded
  • Height: 120 mm
  • Width: 90 / 140 mm (radome / base)
  • Weight: 600 g

proTAC 5311 Installation

proTAC 5311 antenna can be mounted on the mast or on the deck also. Ground plane can affect to antennas performance but not significantly. Because of the ground plane nature, it can’t be isolated from the hull by using plastic sheet between mounting flange and hull. Instead use proISO™ series of galvanic isolators if necessary.

The mounting area should be electrically conductive material like aluminium, steel or carbon fiber in order to fully utilize lightning-and ESD- protection. While mounting, it should be ensured that good electrical contact between mounting flange and the hull is maintained. Especially if it is installed on carbon fiber deck or over thick paint, connection through mounting bolts should be ensured at minimum by separate grounding wire.

Corrosion aspects should also be considered in case of installation over steel structures. Special electrically conductive anti-corrosive paste should be used between hull and the mount.

The cable connector is shielded against water by using the supplied O-ring.


Country of Manufacture: ?